ZBD6800KWW/BB – GE Monogram Fully Integrated Built-In Dishwasher
Dimensions and Specifications (in inches)
• The dishwasher must be installed so that the drain hose is no
more than 10 feet in length for proper drainage.
This Wall Area Must be
Free of Pipes or Wires
• Water and power supply should enter in the shaded area.
• Electrical and water connections are at the right front of the
dishwasher. The hot water line should extend forward 30" to
40" from the rear wall. The electrical must extend forward at
least 24" to reach the junction box.
4"
24"
min.
34" to 35"
Floor to
Underside of
Countertop
• To prevent siphoning, an air gap must be used when the
waste tee or disposer connection is less than 18" above
the floor.
6"
24"
Plumbing and Electric Service
Must Enter Inside This Area
34" - 35"*
24"
24"
Electrical Requirements
The dishwasher must be supplied with 120V, 60Hz, and connected
to an individual properly grounded branch circuit protected by a
15- or 20-amp circuit breaker or time-delay fuse.
Listed by
Underwriters
Laboratories
R
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
For answers to your Monogram® GE Profileor
GE® appliance questions, visit our website at
GEAppliances.com or call GE Answer Center®
service, 800.626.2000.
Specification Revised 8/04
150041
|