EverFocus Security Camera ED200 User Manual

ED200  
INSTRUCTION  
MANUAL  
 
?Follow all warnings and instructions marked on the appliance.  
?Do not overload wall outlets and extension cords as this  
can result in fire or electric shock.  
?Never push objects of any kind into his appliance through  
cabinet slots as they mat touch dangerous voltage points or short  
out parts that could result in fire or electric shock.  
?Do not place this appliance on an unstable cart, stand,or table.  
?The appliance may fall, causing serious injury to a child or  
adult, and serious damage to the appliance.Use only with a cart  
or stand recommended by the manufacturer,or sold with the  
appliance.Wall or shelf mounting should follow the  
manufacturer’s instructions, and should use a mounting kit  
approved by the manufacturer. An appliance and cart combination  
should be moved with care, Quick stops, excessive force,  
2
 
CAUTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK.  
DO NOT REMOVE COVER ( OR BACK).  
NO USER SERVICEABLE PARTS INSIDE.  
REFER SERVICING TO QUALIFIED SERVICE PERRSONNEL.  
The lightning flash with an arrowhead symbol, within an  
equilateral triangle, is intended to alert the user to the presence  
of non-insulated ”dangerous voltage” within the product’s enclosure  
that may be of sufficient magnitude to constitute a risk of electric  
shock to persons.  
This symbol is intended to alert the user to the presence of important  
operating and maintenance (servicing) instructions in the literature  
accompanying the appliance.  
3
 
Note:  
This equipment has been tested and found to comply with the limits for a  
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection. This equipment generates,  
uses and can radiated radio frequency energy and, if not installed and used  
in accordance with the instructions, may cause harmful interference to  
radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the following measures:  
-Reorient or relocate the receiving antenna.  
-Increase these paration between the equipment and receiver.  
-Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
-Consult the dealer or an experienced radio/TV technician for help.  
The changes or modifications not expressly approved by the party  
responsible for compliance could void the user's authority to operate the  
equipment.  
4
 
I. General  
The ED200 Series Camera is a compact, full functioned CCD  
Camera. Their stylish appearance can be applied as per installer's  
ideal locations. These dome cameras can be mounted either on the  
ceiling or on the wall easily. ED200 uses high sensitive 1/3" color  
interline transfer CCD sensor with DSP. The sensor is featured  
with Auto Electronic Shutter, Automatic Gain Control, and Auto  
White Balance function.  
II. Precautions  
Do not expose the camera to humidity and dust. Outdoor  
application without shielding is not recommended.  
Handle with care. This camera consists of sensitive high  
precision parts. Do not disassemble or install it on an  
unstable base.  
Operate on DC +12V. Use a regulated power source only.  
The external adapter is optional.  
Never face the camera toward the sun directly.  
5
 
III. Lens Available  
* Standard board lens f=3.6 mm, F=2.0 mm.  
* Other available lens : -2 Lens f=2.5 mm, F=2.0 mm  
-4 Lens f=4.3 mm, F=2.0 mm  
-6 Lens f=6.0 mm, F=2.0 mm  
-8 Lens f=8.0 mm, F=2.0 mm  
-3P Pinhole lens f=3.7 mm, F=3.0 mm  
IV. Installation Instructions  
1. Remove the plastic dome cover.  
2. Loosen the two screws of the supporting bracket to  
remove the camera body.  
3. Using four screws to fix the camera base on the ceiling.  
4. Put the camera body back to the supporting bracket, the  
connector of the back panel should always be placed to  
camera’s left lower corner, in order to obtain the image of  
best quality. Tighten the 2 screws to fix the camera. Please  
refer to the back panel diagram shows as below:  
6
 
a. Floor Mount  
b. Ceiling Mount  
d. Wall mount,  
aim to the left  
c. Wall mount,  
aim to the right  
5.  
Connect the BNC connector of the camera to a color  
monitor, or other video device through a 75 ohm  
type coaxial cable with BNC female connector at  
cable extension.  
7
 
6.  
7.  
Connect the DC +12V regulated power source  
of the camera (DC Jack) to the DC 12V Power-  
in jack with 2 mm, center+, outer- plug.  
Once the image appears on the monitor, loosen  
the fixing screw located at the lens mount then  
adjust the focus and diaphragm of the lens to  
obtain the best picture. When the ideal picture is  
obtained, secure the lens mount by fixing screw  
firmly again.  
8.  
Put the plastic cover back on the Dome Camera.  
8
 
V. Specifications  
Pickup device:  
1/3“ interline transfer CCD  
510 x 492 (NTSC)  
Picture element:  
500 x 582 (PAL)  
Horizontal resolution: 380 TV Lines  
Sensitivity:  
0.3 Lux/F=1.2  
Over 48 dB  
Up to 1/100,000  
Yes  
S/N ratio:  
Electronic shutter:  
Auto white balance:  
Gamma correction:  
Video output:  
Power source:  
Sync. Mode:  
0.45  
1.0Vp -p, 75 ohm  
12V DC ? 10%  
Internal Sync.  
Lens mount:  
Dimension:  
M12 x P0.5  
106 mm (D) x 85 mm (H)  
Operating temperature:-10°C to +50°C  
Power consumption: 3W  
9
 
VI. Package Contents  
ED200 Camera unit  
User’s manual  
10  
 
EverFocus Electronics Corp.  
Head Office:  
China Office:  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
FAX: +886-2-26982380  
www.everfocus.com.tw  
Room 609, Technology Trade Building,  
Shandgdi Information Industry Base,  
Haidian District, Beijing,China  
TEL: +86-10-62971096  
FAX: +86- 10-62971432  
USA Office:  
www.everfocus.com.cn  
1801 Highland Ave. Unit A  
Duarte, CA 91010, U.S.A.  
TEL: +1-626-844- 8888  
FAX: +1-626-844-8838  
www.everfocus.com  
Japan Office:  
1809 WBG MARIBU East 18F,  
2-6 Nakase.Mihama- ku.  
Chiba city 261-7118, Japan  
TEL : +81-43-212-8188  
European Office:  
Albert-Einstein-Strasse 1  
D-46446Emmerich, Germany  
TEL: 49-2822-9394-0  
FAX: 49-2822939495  
www.everfocus.de  
FAX : +81-43- 297-0081  
www.everfocus.com  
Ihr EverFocus Produkt wurde  
Your EverFocus product is designed  
and manufactured with high quality  
materials and components which can  
entwickelt und hergestellt mit  
qualitativ hochwertigen Materialien  
und Komponenten, die recycelt und  
wieder verwendet werden können.  
be recycled and reused.  
This symbol means that electrical  
and electronic equipment, at their  
end-of -life, should be disposed of  
separately from your household  
waste.  
Dieses Symbol bedeutet, dass  
elektrische und elektronische Geräte  
am Ende ihrer Nutzungsdauer vom  
Hausmüll getrennt entsorgt werden  
sollen.  
Please, dispose of this equipment at  
your local community waste  
Bitte entsorgen Sie dieses Ger ät bei  
collection/recycling centre.  
Ihrer ö rtlichen kommunalen  
Sammelstelle oder im Recycling  
In the European Union there are  
separate collection systems for used  
electrical and electronic product.  
Centre.  
Helfen Sie uns bitte, die Umwelt zu  
erhalten, in der wir leben!  
Please, help us to conserve the  
environment we live in!  
P/N: MED2G0040A  
 

Electro Voice Microphone 660A User Manual
Escort Radar Detector Passport 8500 User Manual
Estate Refrigerator 2318600 User Manual
Exido Scale 246 026 User Manual
Exmark Lawn Mower Lazer Z AS User Manual
Ferris Industries Lawn Mower 5900690 User Manual
Fisher Vacuum Cleaner SC TA3000 User Manual
Furuno Telephone FS 5070 User Manual
GE Microwave Oven Over the Range Microwave Oven User Manual
GE Monogram Refrigerator ZIS360NX User Manual